Olide Electric Magnetic Lock For Max 280kg Swing Door Advantages 

• Made of aluminum alloy

• Anti-theft

Secure desigh with hexagon socket head cap screws and special wrench.Can not be disassembled from outside when locked.

• Delay before close

A delay of 0-15 seconds can be set. (Please check operation guidance in detailed instruction)

• Signal detector feedback

Can output normally open and normally closed signal. Able to be used cooperatively with the alarm system.

• Auti-magnetic lifting pin 

Lifting pin will bounced off the iron. And the strength of elasticity can be adjusted from the back of the iron.

Note: standard lock, delay lock and signal feedback lock has the same size.

Olide Magnetic Door Lock Technical Specifications

Magnetic Lock Different Installation Ways For Different Doors

Standard way to install(no need to use auxiliary stand)

1.If the magnetic lock can be attached to the doorframe, then the installation can be completed without auxiliary stand.

2.Both inswing and outswing can be installed in this way.

3.The width of doorframe should be at least 40mm.

4.Make sure that the rubber gasket is installed to correct the position.

Parallel interior casing(outswing)

1.Need the L-shape stand to support.

2.Outswing use only.(inswing blocked)

3.The height of doorframe should be 45mm or more.

4.Make sure that the rubber gasket is intalled to correct the position.

Parallel interior casing(inswing)

1.Need the ZL-shape stand to support. 

2.Inswing use only.(outswing blocked)

3.The height of doorframe should be 50mm or more.

4.Make sure that the rubber gasket is intalled to correct the position.

Frameless glass door(inswing&outswing)

1.Need the U-shape stand to support.

2.Both outswing and inswing are available.

3.The height of doorframe should be 45mm or more.

4.To match up the U-shape stand, the thickness of the glass door should be no more than 15mm.

5.Make sure that the rubber gasket is intalled to correct the position.

Automatic Swing Door Magnetic Lock Installation Guidance

Stick the sticker then drill accor-ding to the tips on the sticker.	Open the cover with a cross-screwdriver, and disassemble the anti-theft screw with a hexagen key.	Disassemble these four screws at the bootom, draw the mounting plate out.
Install the mounting plate on the door frame, (check two screws into the sliding slot of the mounting plate, mind not clamp too heavily in case that the mounting plate will need to be adjusted.)	After checking the mounting plate is in the right place, clamp the screws to fix the mounting plate.	Attach the lock to the mounting plate by check these four screws at the bottom of the lock with a hexagon key.
Connect wires and install the anti-theft screw	Put the bottom cover on	Install the aligning pins in the iron
Never leave the rubber gasket. Leaving it might cause poor sealing and insufficient force.	Check screw(mind that better not clamp screw too haevily, for the rubber gasket needs some space to stretch)	And it looks like this design sketch if installed properly.

Magnetic Lock Wiring Instruction